Force Global Impulse Heat Sealing Technologies and Solutons
RES DIN-rail
Mount Controllers
RES Panel Mount Controllers
Controller Accessories
Panel Mount Controller Accessories
Validation + Verification
RES Background

Clamp Jaw Bar - Silicone Insulation Backing:

Bar (B)
Step by Step Consumables Assembly Guide.
Bill of Materials:
Force Global Heat Seal Bar B1. Ropex Bar Components.

Step #1
Clean jaw bar surface, remove old tape residue and ensure jaw bar surface is clean and smooth.
Note ... bar preparation is a key step in the creation of a perfect heat seal.

Bar width = 19.0 mm (0.75")
Force Global Heat Seal Bar B2. Ropex Bar Components.
Step #2
Apply silicone jaw bar facing insulation. This wiil compensate for irregular substrates and uneven heat sealing surfaces.
Part No. 100030
Silicone Facing
Durometer 30 Shore A
Roll = 15 m
Upper rounded edges
15.0 mm (Width) x 2.0 mm (Thickness) x 15 m (Length)
Adhesive Backing
Force Global Heat Seal Bar B3. Ropex Bar Components.
Step #3
Apply PTFE tape over silicone jaw bar facing insulation.
Part No. 100892
AP-15, Roll = 30 m
45.0 mm (Width) x 0.15 mm
(Thickness) x 30 m (Length)
Adhesive Backed
Force Global Heat Seal Bar B4. Ropex Bar Components.
Step #4
Optional ... apply masking tape to PTFE Tape sides to aid with adhesion.

This information is provided as a guide to illustrate some of the various heat seal bar configurations that are possible with components and consumables Force Global offer.
This web page is the property of Force Global, Inc. and may not be reproduced in whole or part, nor used for any purpose without the written consent of Force Global, Inc.


P: 414 507-9378
F: 262 628-4451


Jaw Bar Insulation
PTFE Fabric Tapes
Heatseal Bands/Wires
Heatseal Components
Jaw Bar Combinations
Tips and Tutorials